Same tapered threads as the standard innerduct pulling eye, these pulling eyes feature a slotted head with clevis pin to permit direct attachment to any Condux multiple pulling harness leg ends. When properly sized and installed, these eyes will not pull out of the innerduct until the pulling tensions have greatly exceeded the maximum pulling tensions recommended by the innerduct manufacturers.
NOTE: To determine correct pulling eye size, obtain the actual innerduct inside diameter (I.D.). The I.D. measurement must be greater than dimension A and smaller than dimension B.
|
Part Number |
Nominal Size |
Innerduct I.D. Range |
Max O.D. |
Hole Dia. |
Slot Width |
Slot Depth |
Pin Dia. |
Pin Center |
|
|
(in) (mm) |
A - B (in) (mm) |
C (in) (mm) |
D (in) (mm) |
E (in) (mm) |
F (in) (mm) |
G (in) (mm) |
H (in) (mm) |
|
08914310* |
.75" (19mm) |
.71" - .87" (18-22mm) |
1.25" (32mm) |
.25 "(6mm) |
.56" (14mm) |
1.34" (34mm) |
.38" (10mm) |
.59" (15mm) |
|
08914320* |
1.00" (25mm) |
.93" - 1.06" (24-27mm) |
1.38" (35mm) |
.25 "(6mm)Â |
.56" (14mm)Â |
1.34" (34mm)Â |
.44" (11mm) |
.56" (14mm) |
|
08914330* |
1.25" (32mm) |
1.06" - 1.43" (27-37mm) |
1.75" (44mm) |
.38" (10mm) |
.75" (19mm) |
1.78" (45mm) |
.63" (16mm) |
.81" (21mm) |
|
08914340* |
1.50" (38mm) |
1.37" - 1.68" (35-43mm) |
2.00" (51mm) |
.38" (10mm) |
.75" (19mm) |
1.78" (45mm) |
.63" (16mm) |
.72" (18mm) |
|
08914350* |
1.75" (44mm) |
1.68" - 1.81" (43-46mm) |
2.25" (57mm) |
.38" (10mm) |
.75" (19mm) |
1.78" (45mm) |
.63" (16mm) |
.72" (18mm) |
|
08914360** |
2.00" (51mm) |
1.93" - 2.12" (49-54mm) |
2.50" (62mm) |
.38" (10mm) |
.75" (19mm) |
2.50" (62mm) |
.88" (22mm) |
1.23" (31mm) |
|
*Will fit all Condux pulling harnesses |
|
|
|
|
|
|
|
|
|
**Will fit the Condux 3/8" and 1/2" cable pulling harnesses |
|
|
|
|
|
|
|
|
Our Tools for Success
We are proud to be an active contributor to our local communities and to belong to the following professional organizations.
this site and its contents are
© 2024 Jubb Utility Supply Limited
